Rebuilding Segway i2 battery - Page 8

myk57 · 12-23-2022, 04:46 AM

Battman, Roberto's advice helped you

EduAQA · 02-01-2023, 02:41 PM

Roberto, seems that what is been done is what you are saying, did you have done what you GND, cell from 1 to 23, and +?

Ontario · 02-04-2023, 12:47 PM

Quote:

Originally Posted by battman

Hi, I'm an electrical engineer with great experience with building Li-Ion packs. But with segway batteries I have no luck so far! I have burned 3 BMS already so I'm desperate!!

First, just assume, that some BMS are oxideted. May be you do not see it, but as multi-layer PCB, the board is varnished, but the edges are never varnished!
So, in case of humidity, or degraded cells, the vapor going inside the board from ages, and finally board is damaged.

You can't prognosys this, but if you see a bit oxidation on the top of the board - better throw it away.

Regards, Vladimir
Euro Segway Prague

EduAQA · 02-06-2023, 04:35 PM

Vladimir, how about the wires soldering sequence?
P+ (red), cell from 23 -> 1, P- (black)
or
P- (black), cell from 1 -> 23 , P+ (red)
or
other?

02-06-2023, 04:35 PM	#74
EduAQA New Member Join Date: Jan 2023 Location: Orlando, FL Posts: 2	soldering sequence? Vladimir, how about the wires soldering sequence? P+ (red), cell from 23 -> 1, P- (black) or P- (black), cell from 1 -> 23 , P+ (red) or other?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-23-2022, 04:46 AM	#71
myk57 New Member Join Date: Dec 2022 Location: Kazakhstan Posts: 5	Battman, Roberto's advice helped you

02-01-2023, 02:41 PM	#72
EduAQA New Member Join Date: Jan 2023 Location: Orlando, FL Posts: 2	Roberto, seems that what is been done is what you are saying, did you have done what you GND, cell from 1 to 23, and +?

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)