PT (i2/x2) Error Codes & Meanings

[sevenbridges]

My X2 started up fine this a.m......took a little jaunt and then plugged it back in. An hour later noticed one light was green and the top one red. I unplugged it for about 2 minutes and that didn't help. I tried to start it up anyway after unplugging it and got all flashing red lights with EO2F error code. Any help is greatly appreciated. Thank you.

[PeteInLongBeach]

Put the machine in security mode, plug it in to charge, and see if the lights go green after it reaches full charge.

[felix_fetche]

Fault is in front battery,
This is happening when not all the cells are measuring same voltage,
or one cell voltage is out of range.

[CityMech]

Machine starts up, gives error code E044, then shuts back down. At one point the code changed to a E04C. Anybody have any ideas?

Thanks!

[genovesi]

While in the middle of a perfectly lovely glide along the ocean-front road in beautiful Half Moon Bay, I got the dreaded BBBRRRRRRRRRRRRRRRRRT and an E086. Can anyone tell me what this is going to cost me?
CG&Ron

[infinitronics]

E086 is an error in the propulsion subsystem, so it definitely sounds like a power base issue.

Try resetting the Segway by taking the batteries off the base for an hour or so, and then putting them back on and attempting to start the machine up.

YMMV...

[vingale]

Has anyone had E080? I' getting this code with a wrench, and can't find anywhere that tells what it is.

[felix_fetche]

shure E080, not C080 ?

[Ontario]

Originally Posted by felix_fetche

shure E080, not C080 ?

I have C080 error code on one of my machines. What does it mean?

[Toto]

Originally Posted by ryan_walters

Error code C040:

As far as I can tell, this error code is displayed when the wheels loose traction while in rider balance mode. After about 5 seconds of displaying the error message, the segway powers down completely.


I've gotten this twice so far:

Once after getting off to lead it up a curb. It takes a second or two for the seg to drop back to riderless balance mode after getting off, especially if the mats are cold; I suspect they don't 'pop back up' as quick. It was still in full rider balance mode when I leaned it forward for it to go up the curb. With the snow, the wheels didn't have enough traction to climb the curb and started spinning. Because it was still in 'rider' mode, it applies power way quicker than when 'riderless'. It spun the wheels for a second or so, and shuts down with C040.

The second time, also related to snow: Going up a snow covered grass hill slowly. Wheels lost traction (with me on it), forcing me to step forward to avoid falling. Wheels continued to spin for a second until C040 and power down.

I got this error code when experimenting with a jacked Segway. It was "jacked" on a plastic box below the batteries, e.g. to dismount both wheels at a time.
I wondered what will happen when I activate riderless balance mode (by pressing one mat contact down).
Since the whole thing wasn't perfectly leveled the wheels very slowly started to spin in riderless balance mode. By moving the LSF the wheels did respond accordingly - but still quite slowly.
Then I activated rider balance mode (by pressing both contacts of a mat) and was actually a bit surprised that the Segway apparently tried to keep balance with full power and resulting heavy wheel spin for some seconds before powering down automatically. Infokey showed C040 and, I guess, the last measured "speed" of about 30km/h
So just be careful with such experiments...