|
12-21-2012, 07:44 AM | #1 |
Member
Join Date: Sep 2012
Location: Taiwan
Posts: 195
|
Blinking Red LED on Charging [Gen 2]
I have received a X2 with blinking red LED when plug-in to wall.
Battery is fine, as it's running perfectly and i180 charge the battery nicely. Any ides? I've already fixed 2 i170 CSB units due to owner charge the aged battery for long period of time. however I haven't open to study the i2 charging circuits yet, another headache......... Try to find the easy way below is the inside of the CSB unit before repair [IMG]http://i.imgur.com/QFRYJ.jpg/IMG] Last edited by Amimoto; 12-21-2012 at 08:32 AM.. |
12-21-2012, 11:21 AM | #2 |
Advanced Member
Join Date: Aug 2008
Location: Marin County, CA
Posts: 3,783
|
Fixing the above typo so we can see that last image.
__________________
Bob Kerns: To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts. , To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts. Obviously, we can't have infinite voltage, or the universe would tear itself to shreds, and we wouldn't be discussing Segways. |
12-22-2012, 02:57 PM | #3 |
Member
Join Date: Mar 2010
Location: Baia Mare, Romania.
Posts: 166
|
i have one i2 charger on stock,
if you will find some burned component in your charger and you cannot see what is written on it, i cand open mine and give you details about of the part to replace. also can do measuremets in diferent points you may ask. wish uou good luck! |
12-22-2012, 03:12 PM | #4 |
Member
Join Date: Mar 2010
Location: Baia Mare, Romania.
Posts: 166
|
look here! booth leds are blinking, or just one of them?
|
12-23-2012, 02:21 PM | #5 |
Member
Join Date: Sep 2012
Location: Taiwan
Posts: 195
|
thank you so much for the help, both blinking irregularly red (at the same time), I will post more photos of the inside of the unit, with all boards taken out tomorrow, after study the circuits and I am pretty sure what components might be burned out, will give it a try tomorrow.
bit busy today trying to fix a red wrench i167 handle bar, had cut open the heat shrink on the top of the cable where it attach to handle bar and measure all cable to the Elcon connector, all connection and cable is fine, so it is a no fix of this bad handlebar then, waste an hour on that........so I am after a working handlebar now !!!! I am in the constant searching for parts, and does anyone have access to "SEGWAY I2 TOP UPPER CENTER CONSOLE COVER" for sell? this photos are the UIC unit Last edited by Amimoto; 12-23-2012 at 02:42 PM.. |
12-23-2012, 04:31 PM | #6 |
Member
Join Date: Mar 2010
Location: Baia Mare, Romania.
Posts: 166
|
you have to find another UIC, for charging test only. to pwr up is needed to install your radioboard.
if you may have tool to check capacitors on the power source, it would be helpfull. for this unsolder electrolytic capacitors off the pcb to measure them using capacitor meter, check if value is like is marked on them. Last edited by felix_fetche; 12-23-2012 at 06:05 PM.. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|