SegwayChat - View Single Post

drosen · 07-23-2017, 01:42 AM

Hi All:

I recently received a 1st Gen i167 with lithium batteries that had been sitting in a warehouse for while. The batteries are dead and I want to see if I'd be lucky and they would take a charge. It doesn't charge and I'm stuck and need some help.

1. When I plug in the charging cable, I get no lights. When I unplug the cable after about 2 seconds both red lights blink 3 times.
2. I read that the power connector should be a little loose to provide some play, but I think it is too loose.
3. I put a meter on all combinations of the connector holes while the charging wire was plugged in and I got zero volts everywhere.
4. How do I get the rubber mat that goes under the fenders completely off without tearing it so I can take out the torx (star) screws and get to the control board to see if the charging connector wires are intact?
5. If the wires are intact on the control board, what else should I look at and how else should I test the charging circuit, which appears not to be working?

Thanks in advance for much need help ! !

07-23-2017, 01:42 AM	#1
drosen New Member Join Date: Jul 2017 Location: USA Posts: 4	How to test i167 Charging Circuit Hi All: I recently received a 1st Gen i167 with lithium batteries that had been sitting in a warehouse for while. The batteries are dead and I want to see if I'd be lucky and they would take a charge. It doesn't charge and I'm stuck and need some help. 1. When I plug in the charging cable, I get no lights. When I unplug the cable after about 2 seconds both red lights blink 3 times. 2. I read that the power connector should be a little loose to provide some play, but I think it is too loose. 3. I put a meter on all combinations of the connector holes while the charging wire was plugged in and I got zero volts everywhere. 4. How do I get the rubber mat that goes under the fenders completely off without tearing it so I can take out the torx (star) screws and get to the control board to see if the charging connector wires are intact? 5. If the wires are intact on the control board, what else should I look at and how else should I test the charging circuit, which appears not to be working? Thanks in advance for much need help ! !