Thanks to Segway Nation here in Austin, I once again have access to good and red-light batteries, and development continues. I now have Rev AF, AH batteries, and am trying to get my hands on a NiMH battery that still works.
I have updated the pinout on the GitHub image, and am working on weekends to make a breadboard and basic 2-layer gerber/drill file set you can send to 4PCB, ExpressPCB, OSHpark ( etc ) to make an arduino "shield"
I also now have a working 3D STL file so that you can get a connector printed and not have to find the rather hard to get one, and so that you can connect to the battery without having to resort to testing clips.
( It's for development and testing, not for high-current application! Don't use it if you're going to be drawing full voltage from the cell or to charge the cell )
Thanks for your patience Y'all!
For those starting hacking on the cell -- first available i2c bus device is at address 0x31.
Last edited by martinbogo; 01-26-2019 at 03:01 PM..
|