As I understand it, the entire circuit goes like this...
1. white connectors under the csb to the main circuitry
2a. CSB with Power Supply inside, White connectors under and elcon connectors above
2b. CSB with Power Supply inside, White connectors under and Hypertronic connectors above
3a. Coiled wire harness with elcon connectors at bottom, white connectors top
3b. Coiled wire harness with hypertronic connectors at bottom, white connectors at the top.
4. Handlebar assembly, with white connectors below.
If you change 2a with a 2b, you have to also change the 3a to a 3b. You cannot have a 2a plug into a 3b. (or visa versa)
Of course, 3a or 3b is located inside an aluminium tubing set up, but that is not part of the circuit.
I hope this fills in the details. You can remove a 3a from one handlebar, and attach it to a different handlebar, even one that originally had a 3b.
__________________
Karl Ian Sagal
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
"Well done is better than well said." (Ben Franklin)
Bene factum melior bene dictum
Proud past President of SEG America and member of the First Premier Segway Enthusiasts Group and subsequent ones as well.
|