SegwayChat - View Single Post

matchlesspat · 12-19-2019, 01:12 PM

Hi, I have two 2016 X2se segways that I bought dead, I revived three batteries but one has since failed, one is away being refurbished with some new cells,

latest issue is N0.2 seg has fault code E406 CU A MOTOR DRIVE AMP OVERCURRENT FAULT it did have this when I first got it going, with this code if starts to boot up with a smile but within two seconds it shows an unhappy face and shuts down, can this be reset and if so who has the equipment in the UK, near to London if possible?

so used my two good batteries on N0.1 seg but this one seems to have a charging fault where the green light will not go to flashing and when I fired it up the battery indicator showed only two bars when it showed a full house before I charged it, I may need a charger, does anyone have a spare?

at the moment I am charging the batteries on one machine and then swop them to the running machine, Grrrrrrrrrrrrrrrr

12-19-2019, 01:12 PM	#1
matchlesspat Junior Member Join Date: Nov 2019 Location: Essex UK Posts: 18	fault code E406 ??? Hi, I have two 2016 X2se segways that I bought dead, I revived three batteries but one has since failed, one is away being refurbished with some new cells, latest issue is N0.2 seg has fault code E406 CU A MOTOR DRIVE AMP OVERCURRENT FAULT it did have this when I first got it going, with this code if starts to boot up with a smile but within two seconds it shows an unhappy face and shuts down, can this be reset and if so who has the equipment in the UK, near to London if possible? so used my two good batteries on N0.1 seg but this one seems to have a charging fault where the green light will not go to flashing and when I fired it up the battery indicator showed only two bars when it showed a full house before I charged it, I may need a charger, does anyone have a spare? at the moment I am charging the batteries on one machine and then swop them to the running machine, Grrrrrrrrrrrrrrrr