I was considering it would be along these lines of a 'critical error'. Some code built into it to self protect. But if the dealers were able to fix this 'error latch' at some point, there must be a solution, no? Somebody must know. I'm thinking that maybe there is a battery on the motherboard that could be pulled off to release memory of the error mentality. I did notice the other day, which I noticed just before I got it working again, is that when I put the key in, it just beeped once, no display on the circular readout. It did that for a few key prints, and went back to the wrench. It's almost as if it is a software problem.
|