i180 csb w/nut
I removed the shaft clamp bolt and nut completely to gain access to the nut with a long screwdriver. gently tap the nut to loosen it. when re-assembling you can reach in with your finger to start threading the nut and gently tap the nut with the screwdriver to tighten.
My wiring continuity problem were all above the nut so a 6 wire sodering job and a XLR 6 pin connector (replaced on both CS and CSB) fixed the problem.
Even though she runs I want to return it to stock elcon connector before I 'put her out to pasture'. Like alot of us out there just waiting for that great deal on a CSB working or not and elcon CS wiring harness.
-Robert
|