RED with WRENCH - 1st Gen
 

Has anyone determined how to clear the faults, or release the "latch" when the dreaded RED SCREEN with the wrench icon appears?

It seems like one should be able to apply a certain voltage to a certain pin on one of the chips, and successfully reset the machine for testing to determine if a board problem recurs.

This topic was well covered by Philip ( The New Zealand distributor ):

https://forums.segwaychat.org/showth...t=38792&page=2

Sadly Segway did not release any info prior to closing support for Gen 1, so others could assist.

Understood
 

Dgbint:

Yes, I followed all of those threads and had considered reaching out to you, a foremost database on all things Segway, but thought I'd throw this out in case someone was interested in getting seriously into the weeds.

Maybe, someday. In the meantime, I have two XTs. Both ran perfectly until I inadvertently dropped one off the tailgate of my truck. RED SCREEN with the wrench followed immediately.

Thanks for all your past great support.