Does replacing electronic package need a reflash to complete?
I have a X2 that needs some electronic components replaced. Do I need to reflash the operating system after a component swap? Someone told me I did. I have a X2 that was giving error code e042. I replaced the gyro and did not fix the problem still gives same error code. I was thinking about swapping parts from my working i2 one at a time until I figure out which component is bad the X2. Is there any reason that won't work?
|
Does the unit start and operate for a period of time, or does the E042 immediately appear upon start up?
|
A quick search shows:
E042 error which is CU A - BCA down So it seems that the A side control board cannot communicate with the battery. There are 2 likely reasons: 1 A bad battery 2 A dirty ( or broken ) connector. Or even a loose wire inside. Then there's lot more obscure types of errors. Good Luck Michael |
All times are GMT -4. The time now is 03:14 PM. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 2002-2023 SegwayChat.org.
All rights reserved. Not affiliated with Segway Inc.