http://youtu.be/jCOeE8zLLDo

[Wouterjansen60]

Just after 60 km i have noticed a serious and annoying noise produced by the gearbox or wheelbearings on both sides.

Is this a common problem? See this

Wouter

[PeteInLongBeach]

This sounds like gear lash to me, which they all do.

[i2Macman]

Agree with Pete. Sounds like the normal gear backlash to me and is similar to the sounds of my normally operating 2009 model I2. If you are experiencing wheel wobble - side to side wheel wobble, you may consider rotating one wheel should there be some slight flexion in the rim. This is less likely in your new unit but not impossible. Check with your dealer if you have any remaing doubts on either of these issues.
Best of luck and keep gliding often!:thumbsup:

[Wouterjansen60]

Agree with Pete. Sounds like the normal gear backlash to me and is similar to the sounds of my normally operating 2009 model I2. If you are experiencing wheel wobble - side to side wheel wobble, you may consider rotating one wheel should there be some slight flexion in the rim. This is less likely in your new unit but not impossible. Check with your dealer if you have any remaing doubts on either of these issues.
Best of luck and keep gliding often!:thumbsup:


Hi, gearlash is - i think - notable in the direction of driving, not side to side. On the video the movement is side to side, sorry if i was a bit unclear.

Look forward to your oppinion.

Cheers, Wouter

[Wouterjansen60]

Just after 60 km i have noticed a serious and annoying noise produced by the gearbox or wheelbearings on both sides.

Is this a common problem? See this http://youtu.be/jCOeE8zLLDo


Wouter


http://youtu.be/jCOeE8zLLDo

[Bob.Kerns]

http://youtu.be/jCOeE8zLLDo

That sounds pretty normal to me, although either a measurement or tactile feedback would make it easier to judge.

It seems to be about the same amount of axial play that mine has had since new, 5000 miles ago.

It's normal to have some amount of axial play. Tight tolerances don't leave any room for lubrication, thermal expansion, tolerance -- Too tight can actually cause wear, outright failures (less likely in a low-speed application like this) or excess friction (reducing range and increasing load on the motors).

If it's enough to make you concerned, I *would* take that seriously enough to have it checked out by someone. It's just too hard to judge by a YouTube video to give you any blanket assurances. But I would not at all be surprised if your answer is "that's normal".

[IsegPrague]

Thank you for this video, very informative

[electroshock735]

I think that is pretty normal.. The two segways I've had have had that similar play in the wheels

[khosango]

not bad .

[simsodep1683]

✨✨✨ Táº*I SAO PHẢI CHÄ‚M SÓC VIỀN GÂN LOA ✨✨✨
- NgoÃ*i những yếu tố tránh để nắng chiếu trá»±c tiếp vÃ*o loa hay ko để loa trong không gian nóng. Giữ cho loa không bị bụi bẩn thì má»™t vấn đề khá quan trọng đó lÃ* dưỡng ẩm, giữ ẩm cho gân loa của bạn để tăng tuổi thọ gân loa cÅ©ng nhÆ° giữ được chất âm luôn ở trạng thái tốt nhất.
- Bởi Viền nhún: thông thường sẽ được chế tạo bởi chất liệu giấy, vải (xếp gấp lại), có chức năng chÃ*nh chủ yếu lÃ* tạo Ä‘á»™ kÃ*n tÆ°Æ¡ng đối vÃ* Ä‘á»™ mềm dẻo cho loa bass. Do khÃ* háº*u, chủ yếu lÃ* miền Bắc khắc nghiệt hÆ¡n. Vá»›i mùa hè thì nóng mùa đông thì lạnh khô, mùa xuân lại ẩm nồm nên ảnh hưởng đến tuổi thọ của gân loa sẽ dá»… rách, tÃ*ch bụi bẩn cÅ©ng nhÆ° chai cứng theo thời gian. dẫn đến chất lượng âm thanh giảm theo thời gian.
📣📣📣CHÃ*nh vì váº*y #lkaudiozone giá»›i thiệu đến các bạn dòng sản phẩm chÃ*nh hãng Thái Lan #dầu_dưỡng_mềm_gân_loa để cùng bạn chăm sóc vÃ* cải thiện Ä‘á»™ ẩm #viền_loa của hệ thống âm thanh gia đình bạn
👍Dầu dưỡng gân loa Thái lan
- Sản phẩm giúp bạn phục hồi những viền loa đã bị chai cứng theo thời gian lấy lại được độ mềm dẻo.
- Cung cấp Ä‘á»™ ẩm vÃ* thẩm thấu dầu dưỡng vÃ*o viền loa giúp viền loa tăng tuổi thọ cÅ©ng nhÆ° duy trì được chất âm luôn nhÆ° ban đầu
Giá : 190.000VND / bộ
Lkaudio.vn
🐰 0898698986 - 0898698896