07-20-2014, 04:28 PM | #1 |
New Member
Join Date: Jul 2014
Location: Akron, OH
Posts: 9
|
bad control shaft base gen 1
I have 2 gen 1's. XT and I. I was getting the full circle with wrench code, which is platform. I swapped out a lot of stuff, but when I swapped the control shaft base, the XT started. I put the bad csb on the i67 and it starts and runs fine with everything loose, but once I put a bolt in csb, it throws the code and shuts down. Anyone have any ideas or a csb for sale?
|
08-06-2014, 03:46 AM | #2 |
Junior Member
Join Date: Jul 2005
Location: , , .
Posts: 19
|
bad csb or...
just went through this...most probably corrosion.. it's a bad board. good luck board is 800$ new i 167 1000$ GO NRW
|
08-06-2014, 04:46 AM | #3 |
Member
Join Date: Apr 2003
Location: Melbourne, VIC, Australia.
Posts: 991
|
It's an earth leak.
One ( or more ) electrical parts or wire loom parts are leaking to earth ( chassis or casing ). It may be fixable if you have electrical expertise. You need some serious expertise, as this style of fault could potentially cause an electric shock. If in doubt, don't do it as an amateur. Michael www.dgbint.com |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|