bad control shaft base gen 1

scotthill · 07-20-2014, 04:28 PM

I have 2 gen 1's. XT and I. I was getting the full circle with wrench code, which is platform. I swapped out a lot of stuff, but when I swapped the control shaft base, the XT started. I put the bad csb on the i67 and it starts and runs fine with everything loose, but once I put a bolt in csb, it throws the code and shuts down. Anyone have any ideas or a csb for sale?

sofmarmic · 08-06-2014, 03:46 AM

just went through this...most probably corrosion.. it's a bad board. good luck board is 800$ new i 167 1000$ GO NRW

dgbint · 08-06-2014, 04:46 AM

It's an earth leak.

One ( or more ) electrical parts or wire loom parts are leaking to earth ( chassis or casing ).

It may be fixable if you have electrical expertise.
You need some serious expertise, as this style of fault could potentially cause an electric shock.
If in doubt, don't do it as an amateur.

Michael
www.dgbint.com

07-20-2014, 04:28 PM	#1
scotthill New Member Join Date: Jul 2014 Location: Akron, OH Posts: 9	bad control shaft base gen 1 I have 2 gen 1's. XT and I. I was getting the full circle with wrench code, which is platform. I swapped out a lot of stuff, but when I swapped the control shaft base, the XT started. I put the bad csb on the i67 and it starts and runs fine with everything loose, but once I put a bolt in csb, it throws the code and shuts down. Anyone have any ideas or a csb for sale?

08-06-2014, 03:46 AM	#2
sofmarmic Junior Member Join Date: Jul 2005 Location: , , . Posts: 19	bad csb or... just went through this...most probably corrosion.. it's a bad board. good luck board is 800$ new i 167 1000$ GO NRW

08-06-2014, 04:46 AM	#3
dgbint Member Join Date: Apr 2003 Location: Melbourne, VIC, Australia. Posts: 991	It's an earth leak. One ( or more ) electrical parts or wire loom parts are leaking to earth ( chassis or casing ). It may be fixable if you have electrical expertise. You need some serious expertise, as this style of fault could potentially cause an electric shock. If in doubt, don't do it as an amateur. Michael www.dgbint.com

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)