01-27-2015, 09:22 AM | #1 |
Member
Join Date: Jan 2003
Location: Sydney, , Australia.
Posts: 242
|
Gen 2 tire on Gen 1 wheel
Hi
I'm trying to extend the life of my Gen 1 machine as long as possible. Is it possible to put a Gen 2 tire/tube on a Gen 1 wheel? I tried searching the forum, lots of hits, but not on target! Cheers Ronny
__________________
Who said that you shouldn't get carried away on your Segway? |
01-27-2015, 12:33 PM | #2 | |
Glides a lot, talks more...
Join Date: Jan 2004
Location: Pelham, NH, USA.
Posts: 10,356
|
Quote:
I used to add tubes to my gen one tires, because I found that the tubes held air better than the tubeless, and that was all I needed as an excuse. Problem is, the air stem location for the gen 1 tires is not very supportive of a tube air stem. I have forced the stem from the tube into a gen one air stem hole, but it stretches out the tube and may cause a fault, although I did not experience that. I have also drilled a hole in a tube friendly place on a gen one wheel (farther away from the rim) and had good luck with that as well. (If you do this, you should either leave the original air filler and not use it, or plug that hole to support the tube inside. Lastly, you can simply mount the gen 2 tires on the gen one wheels without tubes. They will work fine. The only thing is they will weep air slowly, and that will mean you should check their pressure every couple days, and before all major excursions. If you do this anyway, you should not have much of a problem. I never tried, but you may be able to seal the inside of the gen 2 tire to reduce air leakage, but I had always thought it leaked primarily from the rim, as we only use 15 or less pounds of air. That little air pressure makes it hard to get a good seal at the rim, especially after dropping off a curb or the like. Good luck. Feel free to share with us. Also, as a disclaimer, remember that these are just the ramblings of one guy. What I think is acceptable you may not like. I would not make any major changes or investments on the words of one respondent on the internet. Use your own good logic and common sense. Do what feels right. If it feels wrong, it may be. Good luck. Have fun.
__________________
Karl Ian Sagal To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts. "Well done is better than well said." (Ben Franklin) Bene factum melior bene dictum Proud past President of SEG America and member of the First Premier Segway Enthusiasts Group and subsequent ones as well. |
|
01-30-2015, 09:49 AM | #3 |
Member
Join Date: Jan 2003
Location: Sydney, , Australia.
Posts: 242
|
Thanks for the comprehensive response Karl. Not sure when I'll attempt this, but the day will probably come!
__________________
Who said that you shouldn't get carried away on your Segway? |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|